Installation Guide | Toyota GR86/Subaru BRZ NOVA Series LED Rear Fog Light
Disclaimer
Installation instructions are listed for reference only. You are deemed to have agreed to any slight errors in the vehicle, etc., and AlphaRex and its distributors do not guarantee the final result. Under no circumstances will we or our distributors be liable for damages, misuse or personal injury. If you are unsure of the installation instructions, we highly recommend that you ask a professional mechanic to install it.Remove the original rear fog light
Be sure to turn off the vehicle and make sure it is parked before working.
Use a clip remover to remove the three clips and pull the plastic cover towards you to remove it.
Remove the two 10mm bolts that secure the rear fog light, and separate and remove the rear fog light connector.
LED rear fog light installation
Connect the vehicle connector to the LED rear fog light connector.Install the LED rear fog light using the reverse procedure of removal.
Completed
[When LED rear fog light is turned on in position and the brake is flashing]
*This function will be on and lights are not compliant with safety standards. Please use it only for events etc.
Connect the included extension wire to the passenger side taillight.
Remove the taillight.
Remove the plastic cover of the taillight. The cover is secured with two clips.
Remove the three 10mm bolts securing the taillight, and carefully pull the taillight forward to remove it, separating the connector.
Connecting the wires
Connect the included branch wiring connector to the vehicle's taillight socket. Do not use insulated grease.Remove the waterproof cap of the white connector of the branch wiring that was installed and connect it to the connector of the extension wiring.
After connecting, wire it towards the connector part of the LED rear fog light.Connect the wired connector when installing the LED rear fog light.
[When installing on a vehicle without rear fog lamps]
*It can be installed using a conversion harness, but the rear fog light does not light up so the safety standards are not compliant.
In order to meet safety standards, we can provide the necessary measures by preparing a separate dima switch and rear bumper cable for vehicles with rear fog lights and installing them.
Install using the included conversion harness.
Connect between the vehicle connector and the LED rear fog light connector.LED rear fog lightAttach it to the vehicle.