Installation Guide | Toyota GR86/Subaru BRZ LUXX Series LED Tail Lights
Disclaimer
The installation method is provided as a reference only. You agree that there may be slight differences in the vehicle, etc., and AlphaRex and its distributors do not guarantee the final result. Under no circumstances will AlphaRex or its distributors be liable for damage, misuse, or personal injury. If you are unsure of the installation procedure, we strongly recommend that you ask a professional mechanic to install it for you.Removing the tail lamp
Be sure to turn off the vehicle and make sure it is parked before carrying out this work.

Open the trunk and remove the tail light bolts.
First, lift off the plastic guard cover and loosen the bolts underneath by turning them counterclockwise.

Remove the tail lamp by carefully pulling it outwards.

Separate the plug socket and remove the tail lamp.

Repeat the same procedure on the other side of the tail lamp.
Transplanting brackets


The OEM tail lamp bracket is required for installation.


Loosen and remove the screws and attach the bracket to the AlphaRex tail lamp.
Sequential mode and normal blinking settings


・Normal flashing mode when the Gibushi terminal is connected (connected) ・Sequential mode when the Gibushi terminal is separated (not connected)
*When using the sequential turn signal function, it does not comply with safety standards.
Installing the tail lights

Attach the included conversion harness.
The "Bumper Light" connector is used when installing the AlphaRex trunk garnish (sold separately).
The "Trunk Light" connector is used when installing the AlphaRex rear fog light (sold separately).

Attach the conversion harness to the tail lamp.

Carefully connect the plug socket to the tail lamp.

Install it to the vehicle in the reverse order of removal. Secure it using the bolts you removed. Install the guard cover you removed.



