Installation Guide | 99-09 HONDA S2000 NOVA Series LED Projector Headlight
Disclaimer
Installation instructions are listed for reference only. You are deemed to have agreed to any slight errors in the vehicle, etc., and AlphaRex and its distributors do not guarantee the final result. Under no circumstances will we or our distributors be liable for damages, misuse or personal injury. If you are unsure of the installation instructions, we highly recommend that you ask a professional mechanic to install it.Removing the headlight
Remove the negative terminal of the battery
When doing this, be sure to remove the negative terminal of the battery first.
Remove the front bumper
Remove the five Phillips screws from the plastic metal trim. Next, carefully remove the trim and store it for later reinstallation.



Remove the two 10mm bolts inside the top of the front bumper from both sides.



Fender wheelsWellRemove the two 8mm screws from each side of the


Pull the front bumper outward from the side to remove it from the mounting clip and slowly remove it.

Remove it on the other side using the same procedure.


Remove the nine 10mm bolts under the front bumper.




Remove the front bumper completely. I'll store it for later reinstallation.


Remove the headlight bracket
Remove the four 10mm bolts from the headlight bracket.Do the same on the other side.




Remove the headlight
Remove the 10mm bolts from the side of the headlight assembly, then remove the 10mm bolts from the bottom of the headlight.


Remove the two 10mm bolts securing the top of the headlight.



Remove the headlight assembly by angled slightly. Remove the headlight socket to complete the removal.


Follow the same steps to remove the opposite headlight.




Unfuse and wire the DRL harness
Wire as shown in the figure.
Open the fuse box cover and locate the DRL fuse plug connection. Remove the connector from the vehicle. Then use the included DRL fuse connector harness to apply the fuse.Connect it to the vehicle's socket. Do not use insulated grease.
Connect the red wire to the positive terminal of the fuse box. Next, use the black wire to a negative terminal or body ground.
Close the fuse box cover, organize the wires, and wire the DRL plug towards the headlights.
Install the headlights
Connect the headlight socket to the ALPHAREX headlight assembly.Do not use insulated grease.

Connect the DRL connector.

Connect the turn signal line connector. (Only for the passenger side)

Connect the position connector.

Connect the low beam connector.

Connect the high beam connector.

Connect the turn signal connector.


Attach the headlights firmly to the vehicle and secure them with five 10mm bolts. Repeat the same procedure on the other side of the headlight.




Install the headlights in reverse order from removal, then put the bumper back in place to complete the installation process.




Test the headlight functionality
Test the ALPHAREX headlight functionality and make sure everything works properly.




Adjust the headlight level

Completed

